Sigmaq AMP 2
Classe Audio
> Sigma
> Sigmaq AMP 2
Opis
The Sigma series AMP2 is a 200W/Ch stereo amplifier utilizing switching technologies for both power supply and amplification stages. A Classé-designed switch mode power supply with Power Factor Correction makes over 1,000W of clean and stable power available while being both compact and efficient. A new class D amplifier topology provides wide dynamic range, smooth and extended frequency response and rich harmonic detail to yield stunning sonic performance. The efficiency of class D adds efficiency, low heat dissipation and relatively small size to the list of the AMP2’s attributes.
| All tests un-weighted and 20Hz – 20kHz measurement bandwidth used. | ||
| Frequency response | 10Hz – 20kHz, -1dB into 4Ω | |
| Output power | 200W rms into 8Ω 400W rms into 4Ω | |
| Harmonic Distortion | <0.018% @ 1kHz Balanced Input | |
| Peak Output Voltage |
116V peak to peak, 41V RMS no load 116V peak to peak, 41V RMS into 8Ω |
|
| Input Impedance | 100kΩ Balanced / 50kΩ SE | |
| Voltage gain | 29 dB | |
| Input level at clipping | 1.4Vrms Balanced/SE | |
|
Intermodulation Distortion |
>80 dB below fundamental into 8Ω Balanced | |
| Signal to Noise Ratio | -100 dB at peak output into 8Ω (AES17) | |
|
Rated power consumption |
177W @ 1/8th power into 4Ω | |
| Mains voltage | 100V - 240V, 50/60Hz | |
| Overall Dimensions |
Width: 17.00" (433mm) Depth (excluding connectors): 14.57" (370mm) Height: 3.75" (95mm) |
|
| Net weight | 22.0 lb (9.97 kg) | |
| Shipping weight | 28.0 lb (12.70 kg) | |