|
TA-210 is a static balanced gimbal type arm, easy to use and adjust for optimal VTF settings
• TA-210 has a standard 5-pin DIN connector for tonearm cable
• The tonearm geometry allows for a Baerwald alignment (also the IEC recommendations)
• Counterweight with Inner/outer scale
- Inner scale to be applied with main counterweight
- Outer scale to be applied when extra mass ring is added
• Counterweight will work with headshell+cartridge mass approximately in the range 20 to 28g
• TA-210 is fitted with a standard headshell connector and can easily be adjusted in accordance with the included mounting template
• Extra mass ring for heavier cartridge and headshell combinations included (the extra mass ring may need to be attached to achieve proper tracking force)
• Extra mass ring weight 45g
- Effective mass without headshell: 5 g
- Effective armlength (distance between the stylus and pivot point): 329.0 mm
- Mounting distance (distance between the pivot point and turntable center): 316.6 mm
- Offset angle: 16.5 degrees
- Overhang: 12.4 mm
- Tracking force adjusting range (direct reading): 0-3/0-4 g
- Height adjustment range: 35-55 mm
- Diameter of the armbase mounting hole: 19-20 mm
- Diameter of the center shaft of tonearm: 18.0 mm
- Inner null point: 66 mm
- Outer null point: 120.9 mm
- Counterweight for cartridge + headshell mass between 21 and 28g included
- Headshell LH-2000E included, weight: 15.5 g
- TA-210 total weight including headshell: 536 g
- Set of tonearm cables 6NX-TSW-1010 included
- Extra mass ring for heavier cartridges included, weight: 45 g